Rosendahl nanoclocks GL Manual de instrucciones

- 1 - Instruction Manual nanoclocks GL nanoclocks GL is a digital audio genlock masterclock with 12 word clock / AES11 DARS outputs and

- 10 - The lock range of the nanoclocks audio crystal oscillators is +/- 50 ppm, which allows synchronisation to even strongly distuned audio

- 11 - 6. Sample Rate Enter SETUP and select the new sample rate by pressing the respective button. Button -0.1% will apply a so-c

- 12 - 8. Setup Utility The firmware version installed on your nanoclocks GL is displayed every time the unit is powering up. After a LED tes

- 13 - 9. Declaration of Conformity Rosendahl Studiotechnik GmbH Andechser Str. 5 D-86919 Utting a.A. Germany herewith confirms that the prod

- 14 - 10. Specifications Reference Inputs: A, B 2 x BNC, internally terminated. Video: 300mV sync, +/- 300mV tri-level. auto detection of the fol

- 2 -

- 3 - Contents 1. Unpacking and Mounting into a 19" Rack page 4 2. Connection to Power Supply page 5 3. Installation

- 4 - 1. Unpacking and Mounting into a 19" Rack nanoclocks GL comes with the following accessories: 1 pcs IEC 60320/C14 power cable 1 p

- 5 - 2. Connection to Power Supply Attention! Before connecting to mains please check the voltage selector on the left side panel. Disconnect

- 6 - 3. Installation & Connection Status If you require no more than the 12 word clock/ AES11 outputs provided by the nanocloc

- 7 - Correct termination is quite important to avoid cable reflections, especially for the higher frequency AES11 signals. The nanoclocks

- 8 - 5. Reference REFERENCE = INTERNAL: Press the INT. button to set the nanoclocks to its internal, temperature-compensated timebase

- 9 - Switching from INPUT A to INPUT B does not produce deviations on the synchronised audio clocks, stable operation will be obtained. All lock